I have a lot of design books and they area displayed all kinds of ways throughout my house.  Some are on the coffee table, some are on the console table and some are stacked on a side table.

Everytime I get a new book  (or two) I have an urge to keep it out and display it somehow.  That’s where this DIY project can into play.

I decided to create a simple book stand using inexpensive wood cutting boards.  I purchased a set of 3 cutting boards from HomeGoods.  The set included three graduated sizes and the wood was a natural finish.

To create my book stand I used the large and small size cutting boards and two pieces of unfinished 1 1/4″ x 1 1/4″” piece of wood I bought at Hobby Lobby.  I had to cut about 2″ off each piece of wood so that it was the same length as my cutting board.  Since I had to stain the unfinished wood pieces, I also rubbed some Minwax stain on the cutting boards to darken them up a bit and so they would match the wood pieces.

After the wood pieces were stained I glued two edges together so that one was flat and one was standing and then glued the other edge of the flat piece to the cutting board.  I let the glue set over night.

To create an easel back for the stand I attached the small cutting board to the back of the large one using a piano hinge.  To prevent the stand from sliding when standing I attached clear rubber bumpers to the bottom edge of the small cutting board.

Voila!  A chic book stand that I can use to display my favorite design book of the moment.

Simple DIY projects are my favorite!